Crystal Setup For Home
Please avoid touching the crystal with your hands. We provide gloves for your use to protect the programming. If you prefer, you are welcome to use your own gloves. Always wear gloves when handling the crystal to protect its energy.
Please follow the steps below to set up and activate the crystal:
- Begin by placing the sea salt (included) into the provided vase. Next, add the crystal and fill the vase with water.
- The crystal in the vase will get dirty over time, which is a positive indication of its function. Once a month, or sooner if it becomes excessively dirty, carefully remove the crystal using gloves and wash it with warm water. Please ensure that the salt and water solution is disposed of properly by flushing it down the toilet.
Step 1 – Get the vase ready
Step 2 – Add the sea salt to the vase. Do not Himalayan salt.
Step 3 – Add the protective crystal into the vase with the salt.
Step 4 – Add water into the vase to roughly the same level as shown below:
Step 5 – After a little while it will settle and activate.
Cleaning the Crystal and Vase
Using gloves pour hot water over the crystal to let the salt settle into the vase, then carefully remove the crystal from the vase.
Empty the sea salt and water from the vase into the toilet. Rinse the vase thoroughly with warm water several times until it is clean ensuring that the water is disposed of in the toilet and not the sink.
You may use a limescale remover spray such as Viakal or any suitable cleaning product while wearing gloves to clean the crystal and vase. Avoid using sponges on the vase or crystal as they may harbor negative energy, unless you intend to discard the sponge afterwards or reserve it solely for this purpose.
After cleaning the crystal and vase, repeat the steps to configure and activate the crystal with sea salt and water.
